HP 5064-1913 - Locking cover (Flint Gray) - Attaches to the front of the `Hot Swap` drive trays Retail
HP 5182-6740 - SCSI ribbon cable kit (C13) - Cable clamp and 90 ohm cable with a 68-pin (M) connector marked `To system board` and a high density 68-pin (F) connector with latch clips marked `To External SCSI Port` for the rear panel - 74.9cm (29.5in Retail
HP 5182-9413 - Fast Narrow SCSI-2 90 ohm ribbon cable with termination (C21) - Has a 50-pin (F) connector marked `To array back plane` and two 50-pin (F) connector marked `To unterminated SCSI device` - 47cm (18.5in) long - From one or two Fast SCSI- Retail
HP 5182-4572 - Fast Wide SCSI ribbon cable marked `PCI board to MS cage C15-90 ohm` - Two 68-pin (M) connectors marked `To PCI board` and `To SCSI mass storage device` - 90.7cm (35.7in) long - From hot-swap backplane boards to PCI disk array controll Retail
HP 5182-4574 - Fast Wide SCSI ribbon cable (C12) - Cable is marked `Sys board to MS device C12-90 ohm` - 68-pin (M) connector marked `To system board` and a 68-pin (M) connector marked `To SCSI mass storage device` - 50.8cm (20in) long - From hot-swa Retail
HP 5182-6735 - Floppy drive ribbon cable marked `Flexible disk cable` - 34-pin (F) connector marked `to system board` to a 34-pin (F) old-style edge connector and a 34-pin (F) new-style connector marked `to 3.5 inch flexible disk drive` - 80.8cm (31. Retail
HP 5182-6730 - Ribbon cable - 3-pin (F) connector to 3-pin (F) connector - 40cm (15.8in) long - I2C bus cable assembly (B11) - From hot-swap backplane boards to system (mother) board Retail
HP 5182-6725 - IDE hard drive ribbon cable marked `IDE hard disk cable` - 40-pin (F) connector marked `To system board` to a 40-pin (F) connector marked `To IDE drive` - 74.9cm (29.5in) long - Cable D11 Retail
HP 5182-4579 - Drive power cable (P11) - 18-pin (F) connector marked `BP1` to five cables containing 4-pin (F) connectors marked `P16`, `P17`, `P18`, `P19`, `P20`, `P21`, `P22`, `P23`, and `P24` - Longest cable is 86.9cm (34.2in) long Retail
HP 5063-8390 - `Hot swap` bezel assembly (Flint Gray) - Frame around six `hot swap` drives - Includes the lock Retail
HP 5002-3709 - Filler panel - Covers the empty power supply module slot(s) when the module is not currently installed (Ensures proper airflow in NetServer) Retail
HP 5002-3274 - Lower side panel - Thin strip below the right and left side cover panels (two used) Retail
HP 5041-5325 - Flip down door (Smoked plastic) - Covers the power switch, switch, keyboard lock, and reset buttons Retail
HP 5002-3282 - Processor cooling duct cover - Large metal cover installs over the processor board(s) and memory expansion board Retail
HP 5182-9344 - Heat sink retainer clip - Retainer clip - Holds the heat sink on the Processor IC Retail
HP 5182-9416 - Fixed caster (with locking lever) - Mounts on the bottom of the NetServer (two used) Retail
HP 5063-8329 - Lower bezel assembly - Includes right and left access doors - Covers both of the `Hot Swap` drive bays (Note: Doors are no longer separately available) Retail
HP D3330-60003 - Self paced training kit for NetServer family - Includes service manual, NTSC format video (VHS), and one test Retail
HP 5064-0739 - Control panel board - Includes the display and switches - Control Panel Board (Includes the Display and Switches) - Mounts to the Front Panel Retail
HP 5182-6734 - Fast wide SCSI ribbon cable kit (C3)- Two connector mounting screws and a cable marked Wide SCSI Channel B cable - 68-pin (M) connector to high density 68-pin (F) connector with latch clips for the rear panel - 47cm (18.5in) long - Fro Retail
HP 5182-4550 - SCSI adapter (68-pin (F) to 50-pin (M)) - Used in some configurations for the CD-ROM drive and/or another Single-Ended SCSI drive (Narrow 8-bit to Fast Wide 16-bit) Retail
HP 5041-6342 - EISA Card guide - For the EISA slot boards - Mounts to the chassis assembly (Over the front panel fans) Retail
HP 5063-0328 - Bezel assembly - Plastic cover over the control panel PC board has cut outs for the switches and display Retail
HP 5964-3199 - HP NetServer service and support CD-ROM - Covers LC, LE, LF, LH, LH plus, LH pro, LM, LS, and LX. Retail
HP D3356-69001 - Processor board with a single socket for a 133MHz Pentium processor and six SIMM sockets - Processor Board (with a Single Socket for a 133MHz Pentium Processor IC and Six SIMM Sockets) - Plugs into the System (Mother) Board Retail
HP D3353-80208 - Self paced training kit for NetServer LH series - Includes student workbook, service manual, and test return envelope Retail
HP D4922-63001 - Firmware/software upgrade kit - Required when upgrading from the D2967A/B to the D2967C Remote Assistant assembly Retail
HP 5063-8400 - Ribbon cable with two self adhesive cable clamps and installation instructions - 8-pin (F) connector marked `NetServer` to 8-pin (F) connector marked `Remote Assistant` - 1.0m (39in) cable folded to be 63.5cm (25in) long - From Remote Retail
HP 5064-0795 - Autoranging power supply - 100-240VAC input, 350 watts - For worldwide use - Mounts to the rear panel Retail
HP C3610-69050 - Dual channel PCI Fast Wide SCSI disk array controller board - Dual Channel Fast Wide SCSI Disk Array Controller Board - (P/O C3610A) - Plugs into a PCI Board Slot on the System (Mother) Board Retail
HP D3350-69004 - System (Mother) board - With VGA, IDE and two Narrow SCSI-2 controllers - System (Mother) Board - with VGA, IDE and Two Narrow SCSI-2 Controllers - Large Vertical Board in Center of Chassis Retail
