HP 5042-2144 - Latch clip - Latch clip - Catches the arm from the cover locking latch - Mounts on the front of the chassis Retail
HP D4946-69001 - System processor board - With Super VGA video, Ultra SCSI controller, IDE controller - System (Mother) Board - with Super VGA Video, Ultra SCSI Controller, IDE Controller - Large Vertical Board in Center of Chassis Retail
HP D4944-69001 - Processor board - Has one processor socket - Does NOT include the processor - Processor Board (Small Horizontal Board) - Has One Processor IC Socket - Does NOT Include the Processor IC Retail
HP 5064-0701 - Fan assembly - With housing - Mounts to the rear panel in the upper slot (above the power supply assembly) Retail
HP 5182-9423 - SCSI-2 90 ohm ribbon cable with termination (C31) - Cable is marked `Int. SCSI extension cable C31-90 ohm` - 50-pin (F) connector marked `To array back plane` and three 50-pin (F) connectors marked `To unterminated SCSI drive` - 48.3cm Retail
HP 5182-6789 - Floppy drive ribbon cable - 34-pin (F) connector marked `to system board` to a 34-pin (F) old-style edge connector and a 34-pin (F) new-style connector marked `to 3.5 inch flexible disk drive` - 61.9cm (24.4in) long Retail
HP 5182-6788 - Ribbon cable for one IDE drive - 40-pin (F) connector to 40-pin (F) connector - 51cm (20in) long Retail
HP 0950-3066 - Voltage regulator module (VRM, VRE) - 5VDC input, 2.1-3.5VDC output, 10A, 32W - For Pentium Pro processors - Plugs in socket(s) on processor board Retail
HP D4842-69001 - Processor board - Has two processor sockets, two VRM sockets, and four DIMM sockets - Processor Board (Small Horizontal Board) - Has Two Processor IC Sockets, Two VRM Sockets, and Four DIMM Sockets Retail
HP 5042-2122 - Rubber foot - Replacement rubber foot for the bottom of the computer (two used) Retail
HP 5002-3279 - Hold down bracket - Metal bracket which secures add-in EISA or PCI cards to motherboard Retail
HP 5063-8380 - Bezel assembly - Has cut outs for switches and LED activity lights - Plastic cover over the control panel PC board Retail
HP D8520-63021 - Technical reference card - Includes: power and mass storage cabling, service information, system board diagram, drive locations and settings Retail
HP D8520-63014 - Processor slot terminator module - Plugs into second processor slot when only one processor is installed Retail
HP D8510-69000 - Intel Pentium III `600EB` processor - 600MHz (Coppermine, 133MHz front side bus, 256KB Level-2 cache) - Includes heat sink Retail
HP D8520-63001 - Redundant hot swap power supply - Autoranging 100-240VAC input, 350 watts - Located in the back of the chassis Retail
HP D8520-69000 - System processor board - For up to two PIII processors with 133MHz FSB - Has integrated dual channel Ultra-2 SCSI controller, ATI Rage IIc video, and four DIMM sockets Retail
HP D8520-63013 - Hot-swap fan assembly - Includes three fans - Mounts in the fan Tray in the center of the chassis assembly Retail
HP D8520-63026 - Ultra Wide SCSI ribbon cable with twisted pair segments - One 68-pin (M) connector marked `to SYS BD to H/SWAP` and one 68-pin (M) connector marked `to HOT SWAP` - 1.1m (3.5ft) long Retail
HP D8520-63009 - Floppy drive ribbon cable marked `Floppy disk cable` - 34-pin (F) connector marked `to system board` to 34-pin (F) connector marked `to 3.5 inch flexible disk drive` - 1.0m (3.4ft) long - From 3.5-inch floppy drive to the FDD connect Retail
HP D8520-63008 - IDE CD-ROM drive ribbon cable - 40-pin (F) connector marked `to system board` to a 40-pin (F) connector marked `to IDE CD-ROM` - 33.0cm (13in) long - From IDE CD-ROM drive to the IDE connector on the system processor board Retail
HP D8520-63006 - Cable assembly - 22-pin (F) connector marked `P1` to a 14.5cm (5.7in) cable with a 14-pin (F) connector marked `P2`, 42.7cm (16.8in) cable with two 4-pin (F) connectors, and a 57.2cm (22.5in) cable with two 4-pin (F) connectors - Pow Retail
HP D8520-63005 - Cable assembly - Has an 18-pin (F) connector, a 24-pin (F) connector, and three 14-pin (F) connectors - Overall length is 13cm (5.1in) - Power supply cable Retail
HP D8520-63004 - SCSI ribbon cable - Has 68-pin (M) connectors - 8.0cm (3.1in) long - To the hot-swap cage Retail
HP D8520-63022 - PCI board hold down latch assembly - Includes plastic shell, metal container, latches, and blue tabs Retail
HP D8520-63019 - Front bezel - Mounts to the front of the chassis - Used for rack configuration - Includes right bezel spacer Retail
HP D8520-63018 - Front bezel - Mounts to the front of the chassis - Used for pedestal configuration Retail
HP 5182-6749 - Fast Wide SCSI ribbon cable (C23) - Cable marked `External SCSI port cable C23-90 ohm` - 68-pin (M) connector marked `To system board` to high density 68-pin (F) connector with latch clips for the rear panel - 51.8cm (20.4in) long - Fr Retail
HP J1456B - NetServer LCIIs rack mount kit - Rack mount one or two LCIIs - Contains stationary base, dual sliding shelves, blank panel, and ear panels for the column - (Quartz Gray) Retail
HP D4906-69001 - System processor board - With Super VGA video, Ultra SCSI controller, IDE controller - System (Mother) Board - with Super VGA Video, Ultra SCSI Controller, IDE Controller - Large Vertical Board in Center of Chassis Retail
HP 5183-3418 - Terminator board - Used in secondary processor socket for a system with only one processor Retail
