HP 5182-4598 - Fan jumper (Loopback connector) - For the `Fan 4` (J2G3) connector on the system board (MUST be installed) Retail
HP 5182-6790 - Tubeaxial fan - Two mount to the chassis support bracket (In the front top of the NetServer) and the third mounts to the chassis fan cage (Processor board fan) (Three used) Retail
HP 5064-0750 - Power supply cage assembly (Rev. C) - Includes metal cage with interconnecting board - For hot swap power supply modules (Note: MUST use rev 2 power supply modules only) Retail
HP 5063-8324 - Power supply cage assembly (Rev. A) - Includes metal cage with interconnecting board - For hot swap power supply modules (Note: can use either rev 1 or rev 2 power supply modules) Retail
HP 5182-4581 - Ribbon cable marked `Control panel power cable` - 5-pin (F) connector to 5-pin (F) connector - 1.0m (3.3ft) long Retail
HP 5182-4580 - Power cable asembly - 20-pin (F) connector with two ferrites to 20-pin (F) connector - 94cm (37in) long - From system board to power supply cage (two used) Retail
HP 5182-4578 - Power cable with a ferrite - 14-pin (F) connector to 14-pin (F) connector - 97.8cm (38.5in) long - From system board to power supply cage Retail
HP D4968AR - 512MB ECC DIMM kit - Includes four 128MB ECC DIMMs - Used to add 512MB to a D4967A DIMM memory board Retail
HP D4968A - 512MB ECC DIMM kit - Includes four 128MB ECC DIMMs - Used to add 512MB to a D4967A DIMM memory board Retail
HP 5064-1913 - Locking cover (Flint Gray) - Attaches to the front of the `Hot Swap` drive trays Retail
HP 5182-6740 - SCSI ribbon cable kit (C13) - Cable clamp and 90 ohm cable with a 68-pin (M) connector marked `To system board` and a high density 68-pin (F) connector with latch clips marked `To External SCSI Port` for the rear panel - 74.9cm (29.5in Retail
HP 5182-9413 - Fast Narrow SCSI-2 90 ohm ribbon cable with termination (C21) - Has a 50-pin (F) connector marked `To array back plane` and two 50-pin (F) connector marked `To unterminated SCSI device` - 47cm (18.5in) long - From one or two Fast SCSI- Retail
HP 5182-4572 - Fast Wide SCSI ribbon cable marked `PCI board to MS cage C15-90 ohm` - Two 68-pin (M) connectors marked `To PCI board` and `To SCSI mass storage device` - 90.7cm (35.7in) long - From hot-swap backplane boards to PCI disk array controll Retail
HP 5182-4574 - Fast Wide SCSI ribbon cable (C12) - Cable is marked `Sys board to MS device C12-90 ohm` - 68-pin (M) connector marked `To system board` and a 68-pin (M) connector marked `To SCSI mass storage device` - 50.8cm (20in) long - From hot-swa Retail
HP 5182-6735 - Floppy drive ribbon cable marked `Flexible disk cable` - 34-pin (F) connector marked `to system board` to a 34-pin (F) old-style edge connector and a 34-pin (F) new-style connector marked `to 3.5 inch flexible disk drive` - 80.8cm (31. Retail
HP 5182-6730 - Ribbon cable - 3-pin (F) connector to 3-pin (F) connector - 40cm (15.8in) long - I2C bus cable assembly (B11) - From hot-swap backplane boards to system (mother) board Retail
HP 5182-6725 - IDE hard drive ribbon cable marked `IDE hard disk cable` - 40-pin (F) connector marked `To system board` to a 40-pin (F) connector marked `To IDE drive` - 74.9cm (29.5in) long - Cable D11 Retail
HP 5182-4579 - Drive power cable (P11) - 18-pin (F) connector marked `BP1` to five cables containing 4-pin (F) connectors marked `P16`, `P17`, `P18`, `P19`, `P20`, `P21`, `P22`, `P23`, and `P24` - Longest cable is 86.9cm (34.2in) long Retail
HP 5063-8390 - `Hot swap` bezel assembly (Flint Gray) - Frame around six `hot swap` drives - Includes the lock Retail
HP 5002-3709 - Filler panel - Covers the empty power supply module slot(s) when the module is not currently installed (Ensures proper airflow in NetServer) Retail
HP 5002-3274 - Lower side panel - Thin strip below the right and left side cover panels (two used) Retail
HP 5041-5325 - Flip down door (Smoked plastic) - Covers the power switch, switch, keyboard lock, and reset buttons Retail
HP 5002-3282 - Processor cooling duct cover - Large metal cover installs over the processor board(s) and memory expansion board Retail
HP 5182-9344 - Heat sink retainer clip - Retainer clip - Holds the heat sink on the Processor IC Retail
HP 5182-9416 - Fixed caster (with locking lever) - Mounts on the bottom of the NetServer (two used) Retail
HP 5063-8329 - Lower bezel assembly - Includes right and left access doors - Covers both of the `Hot Swap` drive bays (Note: Doors are no longer separately available) Retail
HP D3330-60003 - Self paced training kit for NetServer family - Includes service manual, NTSC format video (VHS), and one test Retail
HP 5064-0739 - Control panel board - Includes the display and switches - Control Panel Board (Includes the Display and Switches) - Mounts to the Front Panel Retail
HP 5182-6734 - Fast wide SCSI ribbon cable kit (C3)- Two connector mounting screws and a cable marked Wide SCSI Channel B cable - 68-pin (M) connector to high density 68-pin (F) connector with latch clips for the rear panel - 47cm (18.5in) long - Fro Retail
HP 5182-4550 - SCSI adapter (68-pin (F) to 50-pin (M)) - Used in some configurations for the CD-ROM drive and/or another Single-Ended SCSI drive (Narrow 8-bit to Fast Wide 16-bit) Retail
HP 5041-6342 - EISA Card guide - For the EISA slot boards - Mounts to the chassis assembly (Over the front panel fans) Retail
HP 5063-0328 - Bezel assembly - Plastic cover over the control panel PC board has cut outs for the switches and display Retail
HP 5964-3199 - HP NetServer service and support CD-ROM - Covers LC, LE, LF, LH, LH plus, LH pro, LM, LS, and LX. Retail
HP D3356-69001 - Processor board with a single socket for a 133MHz Pentium processor and six SIMM sockets - Processor Board (with a Single Socket for a 133MHz Pentium Processor IC and Six SIMM Sockets) - Plugs into the System (Mother) Board Retail
