HP C7145-60095 - Rack mount kit (Parchment White) - Includes sliding rails, tray, filler panel, and mounting hardware Retail
HP C7145-61601 - SCSI interconnect cable with thumbscrews on both ends - Has high density 68-pin (M) connectors - 26.5cm (10.4-in) long - SCSI jumper cable - Between drive Module and Autoloader Retail
HP C7768C - Ultrium 1/9 LVDS conversion kit - Includes LVDS Ultrium drive, removable 6 slot Ultrium front magazine, Ultrium data cartridge with 100GB native capacity, and cleaning tape - Converts a DLT 1 or DLT 8000 LVDS 1/9 Autoloader to Ultrium Retail
HP C9244AR - DLT 1 or VS80 LVDS connectivity kit - Includes LVDS PCI host bus adapter card, five DLT 1 data cartridges with 40GB native capacity each (80GB with 2:1 data compression), one DLT 1 cleaning cartridge, and an ESD wrist strap Retail
HP C9244A - DLT 1 or VS80 LVDS connectivity kit - Includes LVDS PCI host bus adapter card, five DLT 1 data cartridges with 40GB native capacity each (80GB with 2:1 data compression), one DLT 1 cleaning cartridge, and an ESD wrist strap Retail
HP JL306-61001 - X140 40G QSFP+ LC ER4 SM transceiver - Quad Small Form-factor Pluggable Plus (QSFP+) 4X 10-Gigabit with 1271nm, 1291nm, 1311nm, and 1331nm lasers providing 40-Gigabit connectivity up to 40km (24.9 miles) on single-mode fiber - Has on Retail
HP C5732A - Rail kit for mounting internal tape drives in Power Edge 2300, 4100, 4200, 6100, and 6300 servers Retail
HP C7436A - DDS-4 (DAT) autoloader magazine pre-loaded with five 150m DDS-4 data tapes and one cleaning tape Retail
HP 5063-4251 - Hub accessory kit - Includes two rack mount ears, four rack mount screws, four hub mount screws, and two special cable ties (for front panel cable management guide) Retail
HP J3028-61001 - 100VG transceiver module assembly - Has one RJ-45 Unshielded Twisted Pair (UTP) connector - (J3028A) Retail
HP J3027-61001 - 100VG fiber-optic transceiver module assembly - Has one (Tx/Rx) dual ST type connector - (J3027A) Retail
HP J2608-61001 - ThinLAN transceiver module - Has one BNC connector (10Base-2 port) - (J2608A) Retail
HP J2607-61001 - EtherTwist transceiver module - Has one RJ-45 connector (10Base-T port) - (J2607A) Retail
HP J2603-61001 - AdvanceStack EtherTwist (10Base-T) SNMP module - Provides `In-band` network management for up to 16 hubs - (J2603A) Retail
HP J2962-69001 - Redundant power supply assembly - Has two AC line inputs and four DC outputs for supplying up to four AdvanceStack devices (Separate rack mountable unit) Retail
HP J2585-69011 - 32-bit PCI LAN interface board - RJ-45 connectors - Supports both EtherTwist 10Base-T and 100VG/802.12 - (J2585B, part of J3009B, part of of J3010B) Retail
HP J2577-69001 - EISA 32-bit LAN interface board - Has two RJ-45 connectors - One 10M bits/s 10Base-T and one 100M bits/s 100VG/802.12 - EISA 32-Bit LAN Interface Board - has Two RJ-45 Connectors - One 10M bits/s (10Base-T) and One 100M bits/s (100VG Retail
HP J2573-69001 - ISA 16-bit LAN interface board - Has two RJ-45 connectors - One 10M bits/s 10Base-T and one 100M bits/s 100VG/802.12 - ISA 16-Bit LAN Interface Board - has Two RJ-45 Connectors - One 10M bits/s (10Base-T) and One 100M bits/s (100VG/8 Retail
HP 92214U - ThinLAN cable assembly - Includes BNC (M) to BNC (M) cable 0.5m (1.7ft) long, BNC tee connector (M) and two (F) , and 50 ohm (M) terminator - For hub to hub connection Retail
HP J3235-69001 - AdvanceStack hub 8TXE assembly - Has eight (F) RJ-45 connectors (100Base-T ports) and one MDI cascade port (Note: port 8 cannot be used if MDI cascade port is used) - (Part of J3235A) Retail
HP 365963-001 - Miscellaneous hardware kit - Includes rear removable bracket, floppy tray bracket, floppy retainer bracket, SCSI high density slot cover, blank PCI cover, and screws Retail
HP C1571-60010 - Empty DDS (DAT) autoloader magazine - Holds five data tapes and one cleaning tape Retail
