HP A1824-63005 - Fan assembly - 12cm (4.7in) tubeaxial fan with an attached 27.5cm (10.8in) long two wire power cable with a 3-pin (F) connector - In external I/O card cage Retail
HP A1824-63006 - Ribbon cable and power switch assembly - A 68cm (26.8in) ribbon cable with 10-pin (F) connectors on each end and one attached power switch - For power/LED - In external I/O card cage Retail
HP A3310-69001 - HP PA-RISC processor module - Includes 120MHz processor and 1MB cache - Plugs into the processor (mother) board (One or two can be plugged into each processor board) Retail
HP 0957-0061 - DC-DC converter module (Yokogawa PS601) - 185-400VDC input - +5VDC output, 130A, 650W - (Up to four modules MAY be used depending on number of processor boards installed - Used in slots P1, P10, P2 and P8) Retail
HP 0957-0060 - DC-DC converter module (Yokogawa PS603) - 185-400VDC input - 24VDC output, 325 watts - Supply for the fan power Retail
HP 0957-0057 - High voltage power supply (Astec AA50090) - 169-269VAC input, 350VDC nominal output, 6.3A, 2200W - Includes active power factor correction (PFC) and battery backup - Mounts in the right lower rear of the computer Retail
HP 0950-2246 - Switching power supply (Delta Electronics SMP-264AB REV. B) - 120/240VAC input, 50-60Hz - Three DC outputs, 260 watts - In HP-PB I/O card cage Retail
HP 0950-2232 - MPM DC to DC converter module (Yokogawa Electric Corp. PS604) - 185-400VDC input, eight DC outputs - Mounts in Slot P12 Retail
HP A3310-69002 - Processor board - Does NOT include the processor module(s) - Processor (Mother) Board - Does NOT Include the Processor Module(s) - Plugs into the Upper Card Cage (PMB) Backplane Board Retail
HP A1809-69232 - Service processor board - Service Processor Board - Plugs into the Rear (PMB) Upper Card Cage Slot (Labeled SP) Retail
HP A1809-69001 - Backplane board - Has front and rear slots for the processor(s), memory, and bus converter boards - Backplane Board - in the Center of the Upper Card Cage (PMB) - Has Front and Rear Slots for the Processor(s), Memory, and Bus Convert Retail
HP A1809-60016 - Fan controller board - Fan Controller Board - in Rear of Fan Chassis Assembly Retail
HP 2110-0902 - Fuse - 30A, 600V max - .406in dia. x 1.5in long, metal body - Fuse - 30A, 600V - Part of cable for recovery batteries Retail
HP 2110-0030M - Fuse - 5A, 250V max - .25in dia. x 1.25in long, glass body - Fuse - 5A, 250V - For battery pack - In HP-PB I/O card cage Retail
HP 3160-0809 - Tubeaxial fan (Papst-Motoren Gmbh 6224/4) - 203mm (8.0in) diameter, 51mm (2.0in) thick), 24VDC, 241CFM - Mounts in the fan chassis assembly (11 used) Retail
HP 0957-0058 - DC-DC converter module (Yokogawa PS602) - 185-400VDC input - 5VDC output, 65A, 325 watts - (Up to four modules MAY be used depending on number of memory and bus converter boards installed, in slots P5,P6,P7 and P13) Retail
HP A1809-60051 - External link cable with thumbscrews on both ends - 80-pin (M) connectors on each end - 1.0m (3.3ft) long - From Upper Bus Converter board to Lower Bus Converter board Retail
HP A1809-60049 - External link cable with thumbscrews on both ends - 80-pin (M) connectors on each end - 10m (32.8ft) long - From Upper Bus Converter board to Lower Bus Converter board mounted external of SPU Retail
HP A1809-63002 - AC power cable assembly - 15-pin (F) connector to 25cm (10in) power cord, 25cm (10in) cable with 10-pin (F) connector, and two 9cm (3.5in) ground wires with ring terminals - To power supply in HP-PB I/O card cage Retail
HP A1809-60055 - Cable assembly - Power fail correction (PFC) interface cable - From 350V DC high voltage power supply to HP-PB I/O cardcage Retail
HP 1420-0656 - 6V battery - 6.5Ah, sealed, lead acid battery - Includes 5A, 250V slow-blow fuse and cable - Mounts in HP-PB I/O card cage Retail
HP A1809-60026 - Fan tray chassis - Pull out tray in center of computer - Fan Tray Chassis - Pull Out Tray - in Center of Computer Retail
